FAQs

Ask a Question

What are the recommended Torque settings for the PDL 600 series?

Basically there are no official torque settings for the 600 series, but they are tested to withstand a certain amount of torque.
Sockets like the 695 are tested to 2Nm and 681 are tested to 0.8Nm.
This is the maximum they are required to withstand to pass but for general installation they should only need about one third of this.
Therefore for the sockets you will need about 0.6Nm and for the switches about 0.3Nm.
Was this helpful?
What can we do to improve the information ?